Abacus
Reaction score
287

Profile posts Latest activity Postings Media Albums About

  • I think I remember you doing a ring job with the engine still in the car. Do you remember doing that? I have a 96 B4V that I think has a blown head gasket. The car has 313K on it and I was thinking of doing a ring job while the head is off. Let me know. thanks Dave
    Abacus
    Abacus
    Actually, I never did the rings, I just replaced the head. It still had good compression across all the cylinders and I never saw the need to dig into it further. Even at 383k when I tore the head off I could still see the writing on the pistons and the cross hatching on the bores.

    Mark
    I've taken the plunge on a 96 B4, need an air filter housing, and a top timing belt cover, this thread is pretty old , not sure what if anything is left.thanks, Hans
    Howdee, somehow I lost track of the wire harness between the starter and alternator for a project here. Think you could ship the one on the passat b4 junker to me ? Thanks. Tom
    Hi! What tool did you fabricate for the rear rubber bushings?? I have to do this next week....where are you located??
    Abacus
    Abacus
    Sorry, I didn't see this sooner.
    We fabricated the tool with some 2" end caps and cut/welded as needed. I am located in Dewey, AZ.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top