rrrcryst
Active member
I just compiled freediag-0.3 scantool software on an old A20M IBM ThinkPad. I have a VagCoM serial interface from Ross that I have hooked up to my 1996 Passat TDI.
I can't seem to see the ECU when the software runs. I used every interface listed in the program. It says ISO9141 on the ROSS part. I have also set the SET INTERFACE command to SE9141 and VAGTOOL. Has anyone had experience with this freeware? It seems to run OK after compiling just can't find the ECU.
I can't seem to see the ECU when the software runs. I used every interface listed in the program. It says ISO9141 on the ROSS part. I have also set the SET INTERFACE command to SE9141 and VAGTOOL. Has anyone had experience with this freeware? It seems to run OK after compiling just can't find the ECU.