TQ spec on ALH tranny Motor mount bolts?

[MAXRPM]

I got (18MM Socket), 2 bolts mount to bracket, and (16mm Socket) 2 bolts bracket to tranny, are they the same like for the TB side, I believe 18mm bolts are 74Lbs, and 16mm Socket bolt are 33 plus 1/4 turn?

 

[Metal Man]

I think you should be good there, but I'm not sure of what you are describing for the 16mm head bolts..

 

[Vince Waldon]

The 18mm bolts are single-use torque to yield so there's a torque spec and a quarter turn...probably the same as the other side, as listed in the Timing Belt pdf listed in my sig.

 

[MAXRPM]

Thxs for the reply but on the timing belt side the 18mm Socket bolt, there is no more 1/4 inch turn it is straight 74 ft lbs tq... it used to be 33 plus 1/4 turn if I'm not mistaken

 

[Vince Waldon]

Hmmmm checked the Bentley and ya, no quarter turn on the tranny side.

Here's the relevant page from the manual:

http://imgur.com/canwMMc

 

[MAXRPM]

Thank you I torqued it to 74lbs,

 

[greengeeker]

74 is right. Same bolts as the timing belt end. Good to go

 

[jokila]

Thxs for the reply but on the timing belt side the 18mm Socket bolt, there is no more 1/4 inch turn it is straight 74 ft lbs tq... it used to be 33 plus 1/4 turn if I'm not mistaken

From the timing belt PDF (page 8) the 16mm bolts are 30ft lbs + 1/4 turn, the 18mm bolts were 44 + 1/4 turn. They are essentially the same as the trans side.

The 18mm bolt torque has since been updated to 74 ft lbs with no additional 1/4 turn.

 

[MAXRPM]

Thxs so on the tranny side i did torque them to 74lbs 18mm Socket, but the 16mm Socket bolts, mounted to tranny side should be then 30lbs plus 1/4 turn?

 

[greengeeker]

Correct

 

[MAXRPM]

Thank you I also torqued those to 30 plus 1/4 turn