TDIDaveNH
Left Lane Coal Roller at Large
OK gang,
I need a bit of advice...I'm putting in a set of ARP main bearing studs and notice one end can accept a 5/32 Ellen wrench for tightening....only question I have is...I don't plan on upsetting anything but swap out the bolts for studs. The engine is out and on a stand...do the studs go in and get tightened and how much or just hand tight?
I need a bit of advice...I'm putting in a set of ARP main bearing studs and notice one end can accept a 5/32 Ellen wrench for tightening....only question I have is...I don't plan on upsetting anything but swap out the bolts for studs. The engine is out and on a stand...do the studs go in and get tightened and how much or just hand tight?