Is the front knuckle on TDI B4 same as VR6 ? (ETKA says yes)
- Thread starter TDIL3dad
- Start date
MOGolf
Top Post Dawg
- Joined
- Jun 27, 2001
- Location
- underneath something
- TDI
- 2001 Golf GLS TDI Reflex silver, rough road suspension and steel skid plate, 2004 Passat Variant, Candy White, rough road suspension and geared balanced shaft module, and much, much more. 2016 LR RR HSE TD6, 2019 Jaguar I-PACE
I see the same thing. I plugged the numbers in at parts.vw.com and it shows what models they were installed in.
255 (left side) is no longer available but interestingly 256 (right side) is.
However, the question in the title is about VR6 models. I found 1H0407255/6 for those in Jettas and Passats with VR6 (AAA) engines.
255 (left side) is no longer available but interestingly 256 (right side) is.
However, the question in the title is about VR6 models. I found 1H0407255/6 for those in Jettas and Passats with VR6 (AAA) engines.
Last edited:
Steve Addy
Top Post Dawg
Steering knuckles (spindle, bearing carrier, etc) for 4 cylinder cars are the same, only for 6 cylinder will they be different. Same goes for control arms. 4 cylinder are same gas to diesel (and same side to side) but 6 cylinder are different and specific for each side.
This is for NA imports.
Steve
This is for NA imports.
Steve
Steve Addy
Top Post Dawg
As I mentioned I put a feeler out but there's not a lot of Mk3 GTI VR6 or Jetta GLX VR6 interest around here so I'm not holding out much hope. Also, junked B4 VR6 cars are few and far between so that doesn't help either.
Steve