fleuryperformance
Active member
Hi guys,
I just did a complete overhaul of my ALH engine. I've putted it back in the car today. I plugged all of the wires, hoses & sensors at their factory location.
Once I got to the step of plugging in the glow plug wiring harness, I realized that the wires at the other end were cut. I just bought the car, that's why I didn't realize it before. So the previous owner cut the glow plug wire (They are not connected to nothing) and sliced/added two additionnals wires. The first wire goes to the engine speed sensor connector (purple one in the picture at the end) and the second is connected after the blue wire of the old glow plug wiring harness.
I followed these two added wires to the interior of the car and the whole thing is connected to a s**** load of wires then connected to a transponder with a key inside.
My question is the following. I want to put everything back to original. Can I remove the transponder without compromising the operation of the car? I have never seen these systems on any of my vehicles. Also, I would like to know where are the 4 cut wires of the glow plug wiring harness connected to normaly?
Thank you very much for your help.
Pictures :
https://ibb.co/DkDpmf8 (Inside the transponder box)
https://ibb.co/NSw39pX (The transponder box)
https://ibb.co/Hgt3GVy (Yellow wire that are sliced/connected to the BLUE wiring on the old glow plug harness)
https://ibb.co/nDbqgJ8 (Purple wire that are sliced/connected to the engine speed sensor connector)
https://ibb.co/MNZKmCj (The wires that are cut from the glow wiring harness)
https://ibb.co/4KMcYbm (My new motor that I've just built on the last month)
I just did a complete overhaul of my ALH engine. I've putted it back in the car today. I plugged all of the wires, hoses & sensors at their factory location.
Once I got to the step of plugging in the glow plug wiring harness, I realized that the wires at the other end were cut. I just bought the car, that's why I didn't realize it before. So the previous owner cut the glow plug wire (They are not connected to nothing) and sliced/added two additionnals wires. The first wire goes to the engine speed sensor connector (purple one in the picture at the end) and the second is connected after the blue wire of the old glow plug wiring harness.
I followed these two added wires to the interior of the car and the whole thing is connected to a s**** load of wires then connected to a transponder with a key inside.
My question is the following. I want to put everything back to original. Can I remove the transponder without compromising the operation of the car? I have never seen these systems on any of my vehicles. Also, I would like to know where are the 4 cut wires of the glow plug wiring harness connected to normaly?
Thank you very much for your help.
Pictures :
https://ibb.co/DkDpmf8 (Inside the transponder box)
https://ibb.co/NSw39pX (The transponder box)
https://ibb.co/Hgt3GVy (Yellow wire that are sliced/connected to the BLUE wiring on the old glow plug harness)
https://ibb.co/nDbqgJ8 (Purple wire that are sliced/connected to the engine speed sensor connector)
https://ibb.co/MNZKmCj (The wires that are cut from the glow wiring harness)
https://ibb.co/4KMcYbm (My new motor that I've just built on the last month)