tbones
Veteran Member
- Joined
- Dec 22, 2005
- Location
- Annapolis, Maryland
- TDI
- 1996 Passat wagon tdi, 1991 Corrado TDI (sold)1983 Vanagon 7pass.GL 1.6td 1982 Westy;THE PHOENIX 1.6na(NOW JX/5speed) my partner's 2014 Jetta Sportwagon 6spd manual AND MY NEW TOY/PROJECT... Sunny, a bright yellow 87 syncro Westy with 1Z TDI motor
HI All,
I have a flashing lights on this new-to-me 1996 Grey Passat wagon, and could use some pointers.
Back story:
I'm still looking for the "perfect" replacement motor for the 1.6TD currently in the PHOENIX (my 1982 Vanagon diesel Westy).
I'm planning on a 1Z/AHU... hopefully to be an E-TDI, and have purchased TWO 1Z powered vehicles recently, looking for the "right" one.
I'm NOT tearing apart the nice 1998 A3 I acquired off of this site from Georgia (long story) and I MIGHT use the 1Z motor in the B4V i just rescued from a junkyard in PA that another club member had to get rid of quickly.
Long story short, this B4V runs, albeit anemically, and now that I got a cable to read my VAGCOM, I'm finding the codes showing are these:
Two Faults Found:
00542-Needle lift sensor (G80)
05-00 input open
00310-CAT Temperature Sensor 1 (G20)
30-00 - Open or Short to Plus
Can someone please let me know what I should look for in order to correct these?
thanks again for all your help, and patience in this project!
regards,
Steve
I have a flashing lights on this new-to-me 1996 Grey Passat wagon, and could use some pointers.
Back story:
I'm still looking for the "perfect" replacement motor for the 1.6TD currently in the PHOENIX (my 1982 Vanagon diesel Westy).
I'm planning on a 1Z/AHU... hopefully to be an E-TDI, and have purchased TWO 1Z powered vehicles recently, looking for the "right" one.
I'm NOT tearing apart the nice 1998 A3 I acquired off of this site from Georgia (long story) and I MIGHT use the 1Z motor in the B4V i just rescued from a junkyard in PA that another club member had to get rid of quickly.
Long story short, this B4V runs, albeit anemically, and now that I got a cable to read my VAGCOM, I'm finding the codes showing are these:
Two Faults Found:
00542-Needle lift sensor (G80)
05-00 input open
00310-CAT Temperature Sensor 1 (G20)
30-00 - Open or Short to Plus
Can someone please let me know what I should look for in order to correct these?
thanks again for all your help, and patience in this project!
regards,
Steve