VAG COM results, Now What.

[eandelin]

Here's what I found:

I need suggestions on the Glow Plug issue. The MAF I can deal with.

Address 01 -------------------------------------------------------
Controller: 038 906 012 CP
Component: G100SG 2839
Coding: 00002
Shop #: WSC 00000
2 Faults Found:
16486 - Mass Air Flow Sensor (G70): Signal too Low
P0102 - 35-10 - - - Intermittent
16764 - Glow Plug/Heater (Q6) Circuit Malfunction
P0380 - 35-10 - - - Intermittent
Readiness: N/A

Opinions? Solutions? Parts recommended? Supplier?

Thanks in advance.

 

[GoFaster]

Get out the digital multimeter, and perform the measurements on the system that are in the TDIFAQ troubleshooting section.

 

[GeWilli]

after you check the resistance of the glowplugs clean off the connector on the plug and try reseating the harness. I had to do that a few times to get the CEL from teh glow plugs to go away...

 

[eandelin]

It appears that one of the connectors was jostled a little.
Pulled them all of gave them all a shot of compressed air to clean out any debris and put them back on.

Used the VAGCOM to clear the codes, drove all night, no problems.

Thanks, for the tips!