Mk4 Jetta Seat Cupra R Bushings Alignment

[VAGDaddy]

Posting as I'm going to do the rear beam axle bushings with the Seat Cupra R Bushings. I've seen a lot of conflicting information on bushings alignment/position when installed into the rear beam, checked All Data and it was non conclusive. Can anyone shed some light on how these bushings are supposed to be installed in the rear beam?

Sidenote, my rear beam has the hydro bushings in it. Will they press on the same as the normal rubber or is there additional modification required? Repair manual states the hydro bushings are non serviceable and to replace the entire rear axle if they go bad. Thanks you guys!

 

[Nuje]

We beat this one to death....and then picked it up, dusted it off, and pummelled it some more, just for sport, a few years ago.

Cupra R rear bushings - orientation?

I spent an hour reading many different how to's on changing the rear axle bushings, and couldn't find any mention about how to clock the Cupra R bushings. Kerma's site says they stripe their bushings so the end user can clock them correctly . The Febi set I have from Idparts that I bought...

forums.tdiclub.com

 

[VAGDaddy]

We beat this one to death....and then picked it up, dusted it off, and pummelled it some more just for sport a few years ago.

Cupra R rear bushings - orientation?

I spent an hour reading many different how to's on changing the rear axle bushings, and couldn't find any mention about how to clock the Cupra R bushings. Kerma's site says they stripe their bushings so the end user can clock them correctly . The Febi set I have from Idparts that I bought...

forums.tdiclub.com

Thanks for posting the link, have no idea how I missed that thread. Just going to install them per the manual screenshot, should get me close enough lol. Glad I could add to the chaos lol.