- Dec 27, 2004
- Jetta Wagon 2003 TDI tuned to 170HP, A6 Wagon 2008 TDI 2.7L tuned to 340HP
I just installed the 3 bar map and got CEL with DTC 16490 Manifold / Barometric Sensor (G71) / (F96) : Implausible Signal P0106 35 00. I had recently upgraded to 1722 turbo and pp764 everything was fine. Today as soon as I put in the 3bar map I lost all boost. The ECU is specifying different boost when I drive around, I logged some data group 10, 11 but the actual is always at atmos pressure. 999.6 mbar. Is this is a rc3 tune for 2.5bar sensor issue? i.e. is the voltage from the 3bar sensor much lower than the 2.5bar sensor and it is confused? Some folks were saying it would boost more with 3bar map, in my case it is the opposite. Unless it is connected properly, but i made sure it was ok and the wire is not damaged by the pulley or anything.