Can I take the top off my ahu injector pump

[lews930]

The threaded port for my banjo bolt is stripped out. I've got a core pump with good top. Can i unblock and replace?


On a side note. Can i remove the plate on the side of the pump where the harness goes in?
The wire harness is a little boogered up and I'd like to make it fancy



thank you

 

[KLXD]

You can swap the tops. You should use the fitting from the original pump. I've heard the valve in the fitting is matched to the relief valve in the pump.

Need the fancy socket for the triangular head bolt. Can make on from a 7mm six point with a small grinder.

To remove the plate on the side you have to break the welded connections inside.

 

[lews930]

Ok. Thank you !