ALH Mass Airflow Connector

[TDI Jim]

I noticed when changing my mass air flow sensor there are 5 prongs on the sensor and only 5 female connectors in the plug. Is this correct or is my plug missing the 5th connector? Thanks for your help everyone!

Sent from my SM-N910V using Tapatalk

 

[Windex]

Yes.

terminal chart:

 

[TDI Jim]

Yes.

terminal chart:

Thanks Windex. I got a repair plug and wires from ID parts, so will start working on it.
Just took the back off the cinnector and only see red, green, black and yellow (with black stripe) wires in the wiring harness, so may have to visit a junkyard, unless there are any other suggestions?

Sent from my SM-N910V using Tapatalk

 

[TDI Jim]

Thanks Windex. I got a repair plug and wires from ID parts, so will start working on it.
Just took the back off the cinnector and only see red, green, black and yellow (with black stripe) wires in the wiring harness, so may have to visit a junkyard, unless there are any other suggestions?

Sent from my SM-N910V using Tapatalk

My bad, there are only 4 connectors, so plug is correct as is, got it now, thanks Windex!

Sent from my SM-N910V using Tapatalk

 

[YakdOff]

Yes.

terminal chart:

Hi Windex, on my Mk6 2010 Jetta the MAF wires were ripped out of the plug and I am trying to repair with a new pig tailed D-plug. The plug is 5 wire but the middle is empty so it's a 4 wire MAF. Is it reasonable to start with the pinout you inserted above?

 

[BobnOH]

Might be best to get a wiring diagram.

 

[The Cream Dolphin]

Hi Windex, on my Mk6 2010 Jetta the MAF wires were ripped out of the plug and I am trying to repair with a new pig tailed D-plug. The plug is 5 wire but the middle is empty so it's a 4 wire MAF. Is it reasonable to start with the pinout you inserted above?

The above picture is a mk4, if yours is mk6, find a correct diagram. Make a new thread in the mkvi forum and surely (not Shirley) someone with a bentley manual can help out.