Is it ok to use again after catastrophic failure (valve fell into cylinder) forged aftermarket conrods? Engine block and piston are trash, but conrod looks straight and there aren’t any visually noticeable defects or damages.
These are the conrods which were used:
These are the conrods which were used:
Audi / VW 1.9 2.0 PD 2.0 16V CR TDi FCP H-beam steel connecting rods 144mm
Part number FCPRHVW14453726FCP Engineering H-beam steel connecting rods kit (4 pcs.) 144mmVW Passat, Bora, Jetta, Golf IV, Golf V, Golf VI / Audi A3, A4 / Seat Toledo, Leon, Ibiza:1.9 TDI PD 96-110kW (ARL, ASZ)2.0 TDI PD and 2.0TDI 16V 100kW, 103kW, 125kW (CBDA, AZV, BMM, BKD, CBDB)
fcp-engineering.com