Proper use of a syringe:
http://www.murphysmachines.com/how_to/how_to_syringe.html
How to Titrate:
http://www.murphysmachines.com/how_to/how_to_titrate.html
All about collecting oil:
http://www.murphysmachines.com/how_to/how_to_collect_wvo.html
Hope this helps,
If anyone is interested in building a super sucker to collect oil but doesnt know how, I finally finished plans for it.
http://www.murphysmachines.com/supersucker.html
Hope this helps..
I posted this before but the threads aged off the board so here it is again.
BioDiesel Titration Instructions
http://www.murphysmachines.com/how_to/how_to_titrate.html
Collecting WVO
http://www.murphysmachines.com/how_to/how_to_collect_wvo.html
Chemicals Locator...
Whew.. finally finished it..
This should be a good article for newbies.
If anyone disagrees with any of what I wrote, please speak up. As always, I'm open to suggestions.
http://www.murphysmachines.com/how_to/how_to_collect_wvo.html
When I sold my biodiesel system I got hammered with so many emails asking for directions to build it.
Here they are,
http://www.murphysmachines.com/biodiesel_processor.html
All the chemical supplier information from various biodieselers in locations all over the globe has been compiled and organized into a single page found here:http://www.murphysmachines.com/resources/suppliers_locator.html
We will be creating a way for visitors to add information to the database...
I've been getting requests for these so I put up a set for all to use as a guide.
This is for newbies.
http://www.murphysmachines.com/how_to/how_to_titrate.html
I know this isnt a waste oil forum but I used to freeze my rear end off working in my shop so I thought I should post this.
I built this shop heater because it was getting cold. A few people saw it and asked if I would be willing to draw up plans for them to buy. The thing works so good I've...
I am selling my processor.
Pictures below.
What's included in the sale:
Qty 1 Insulated 63 Gal Cone Bottom Biodiesel reactor.
(With Harbor Freight Pump not shown)
*Two 4500W@220V heating elements.
*Reactor heats up in 30 minutes on average.
*All piping is 1 inch or larger Black Iron Pipe...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.