Search results

German Auto Haus Marietta Ga.

Reinhardt's German Auto Haus 4919 Canton Rd. Marietta Ga. 30066

Good news car is fixed, problem was the ECM was bad replaced with a rebuilt one and programed it with the vin # the shop told me it had quit communicating. Word of advice do not take your VW to a shop that doesn't have the VW test equipment.

I have sent the car to a shop that has the VW test equipment.

I have the car in a shop now and have been told the tank lift pump pressure is low 5 psi, what I have read is that a pressure of 5 to 7 psi is normal, the car will run using an alternative fuel supply for a short period of time until the fuel runs out, this shop has been very good but vw tdi may...

Did that both brake lites work normal.

Engine turned over normally, tail lites are working normally, heard fuel pump work,

As expected the glow plug harness fell apart,. and the glow plugs are the original, so I will change both, is there a vw code reader I can buy for a reasonable amount.

No code shown, checked glow plugs with ohm meter, all read about .9 to 1.0 ohms, also checked voltage from harness read 5.9 to 6.0. Lite comes on steady for a few seconds then starts to blink and at that time the voltage readings go to zero. Is there a timer and where is it. fuses have been...

Will it show a code with out the eng. running,I have an obd unit.

2006 vw jetta 208k miles outside air temp 43f tried to start the glow plug lite blinking, would not even try to start no other warning lites on, ckd brake lites ok, no previous problems even with colder weather.

how do you drop the light receptacle that holds the bulb for the vanity mirror on a 2006 vw jetta it is the one in the headliner

I replaced the after market one with the original bosch one, the vw people told me that both were ok same problem today. I tested the wires at the maf connecter for the correct readings it is a 4 wire plug here is what they read #1 no wire #2 wire input voltage from pwr relay to ecu12v #3wire...

It was aftermarket are they a big problem. Will a vcds tell any thing more than the dealers diagnostic equipment does. I do not know anybody who has a vcds I live near Atlanta at this point the cost of a bosch maf sensor is about $135 and I think a vcds cable is about $200 right now I need to...

cel came on obd shows maf problem have spent $2000 + so far replaced maf sensor.replaced cam and lifters, egr valve, n31 relay, f 75 relay,egr cooler replaced, ecu replaced with rebuilt one,Cleaned intake plumbing vw dealer used their diagnostic computer to check vehicle 2006 jetta tdi. Will...

06 jetta tdi cel help

the ecm came out of another car and according to the dealers and shops it must be programed to match the car the immobilizer has been deleted I have sent an e mail to Malone see what they have to say