Search results

I went to tekmektronics

Fluid is fine but I found my new slave is leaking

No load noises. Just steady loss of pedal, gear shifts started getting harder then one stop sign it just would go into gear and the pedal was to the floor and wouldn't come back.

Ok so the 4 gear issue was resolved by adjusting the shifter linkage per the instructions lol duh. I bleed the clutch and boom we had a driving car! Took it for a run and heard a pop and then I couldn't get over 55 mph. Turns out someone had the clip on the turbo flipped and it didn't engage...

Thanks. I just read up on the adjustment process. I plan to that and bleed the clutch this weekend.

So i had 2 gear selectors to work with. Not sure what ech came from but they look exactly the same minus a bump stop. I took all the best looking parts and put them in my car. When it came to the selector rod, one was just a clean rod and the other had a small bumper on it. I installed the...

I got that part right

That seems probable. I think the 4 gear issue is related to the linkage i used. I had 2 to choose from and the one I chose had a rubber stop on it. I think it might be restricting me from getting to 1 and 2.

I am sure that im unsure lol. I bleed the clutch once but i did that before bleeding the brakes. Not sure if that would impact it. Im going to try bleeding it again. This is my first experience with a manual so its all new to me.

Well new problem. Went to take her out for the first drive and Im only getting 4 gears will moving the shifter when the engine is off and when its on it won't go in any gear lol I'd assume there's some sort of adjustment i messed up with the shifter linkage. Anyone have an idea off hand?

And a year later. Here we are. Going for a test drive a little later.

https://www.urotuning.com/products/intermediate-plate-06b103551g?variant=8392240726071 This is the one I bought. Fit perfectly.

The plate between the gearbox and engine? I bought a new one and installed it. Are you referring to something else?

Ya clearanced all the way around after I JB welded the cracks. Bolted it up and said "Thats not going anywhere".

Ok that makes sense. This car was in front end collision at some point so maybe they just used whatever. Thank you. I was starting to tear everything back apart lol.

Ok so been a bit, here is some progress and a few questions. Engine and trans is in and bolted up. Im just connecting the last few things in efforts to start her up in the next week. Had 2 questions for you all. 1. What did you all do for capping the radiator from the old trans cooler lines...