Search results

I AWD swapped my Jetta and put a 6 speed 02M in.

Hello, I am interested on the GTD2060VZ it says it is a ball bearing turbo, but as far as I know it is not a ceramic ball bearing. Thanks https://en.powertdi.pl/gtd2060vz-,p,185,0

ALH Piston & Rod options with measurements

Hi, not wanting to jack the thread, but I wanted to ask if pin out 4 would read 0-100% Thottle gradually or does it only read it at 25% increments? Iv got a stand alone controller that I need to have a 5v Thottle position signal from and I need it to read 0-100% all the way through. Example: 5%...

South Bend Clutch stage 2 endurance for the 02M is quite and has like 0 vibration. Holds like 450 ft-lbs. 21lb flywheel I believe, and it feels really good. K70287-HD-OCE-SMF

The grounds were all very clean under the tray, since I ran the found under the battery tray, I've had 0 issues with it. ID Parts has you ground in the relay box above the brake master, and to the glow plug relay ground I believe.

Attention ALH owners that have installed a PD lift pumps or are going to install a PD lift pump. If you have used the ID parts installation guide, you may need to change the ground that comes from relay 53 that they suggested in their instructions...

I went a different rout with my build. I picked up a 6 speed 02M DVR Transmission that came from Europe. The cost is actually lower than doing the 6th gear add on. Korwerks LLC. is where I got mine. you can also get a rebuilt Euro 6 speed from dutchautoparts.

I met with Owain a bit ago and put the TDI with the S7 to the test at Malone's shop. now I did a full write up on the Malone vs kermaTDI tune, but there you can find more logs and dyno sheets for the BW S7. http://forums.tdiclub.com/showthread.php?t=489446 Malone Dyno...

i have received mine now.

Yes this works. But there are a few different gear ratios for the 02M diesels in Europe.

Love the build. I am just finishing an AWD swap into my TDI and thinking of the GTB2060VKLR.

Cool Ending.

Rod length Hey Frank, Iv had ppl asking me if the Molnar rods are shorter than stock rods on the ALH and if they need to deck the block? Unfortunately I lost my images and measurements of my Molnar rods so I cannot confirm. But I know I did not need to deck my block. Please confirm this for...

This code is good for 1 week only. So get it now before it is too late �� The fire extinguisher can be mounted to both passenger or driver's side. This code is good for any mount on Russell's site. The fire extinguisher cannot be shipped, so please do not add this to your cart. If it...

Hey, even thought we started out with nearly 300 members interested in the fire extinguisher mount, unfortunately we did not reach our 200+ members in the final count. BUT GOOD NEWS, Russell with KAP Industries is still really excited to have so many MK4 lovers interested, he is going to make up...

I will be seding PMs soon. thanks

What was the verdict on this short to ground? Having same issue with my dad's car, cannot connect with VCDS or any other scanner I have.

combination of platforms. we dont need 200+ for the buy either, that is just to hit that price mark.