I cut back the wire already and put a new connector on it. Did not need to splice any wire as I only took off about 1/4 inch of wire. It goes into the a wiring harness that is all taped up along the firewall.
Thanks Todd. Do you think the wire connector looks bad? The metal frayed section was about 1/4 inch without insulation.
So the control module box should still be good? I thought it might have as circuit board in it that might have got toasted. I replaced it 6 years ago when I could still get...
Connector and plastic box melted on the small Allen bolt and lug in the top right corner of the module where the red hot lead comes in. Took out the control box and used a dremmel bit to remove melted plastic. Lug was about 1 inch away from its hole. Siliconed it back in place. Got so hot it...
Rebuilt Instrument Cluster out of 96 Passat TDI. Part #3A0 919 910 H. Can be set to whatever milage you want. Had 202,479 when rebuilt. Milage is reset to 256, but it can be changed. Everything works including clock and lights. Fort faster service, call 303-327-9697.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.