Search results

Oilhammer, I'm very sorry for your loss. Remember the good times with your son.

99,000 on 2001 Jetta. It hesitates ever so slightly when engaging in drive or reverse. Otherwise it works great. I'm going to set my code to 00011 and set how it does.

Please explain venting. Is it possible to vent a 2001 Jetta? I don't see any valve as mentioned on other posts. Maybe a PO removed mine.

There are probably more, but I know of a couple of causes. You could have an air leak in the fuel system, probably at the o ring on the fuel filter, leaking and letting in air. Another cause is when the timing is way advanced it will caused air bubbles. It did in my car. Once I got the...

I think I should go down to the local "friendly" DMV and see what they tell me. There are two offices within 10 miles of my home and one will frequently do what the other one says can't be done! What Jim did with his (in the thread above) seems logical and if it worked in central NC, it is...

Has anyone ever done the chain of paperwork through the NC DMV when converting a vehicle already registered in NC? My son in law has a Toyota Tundra with a bad engine soooo you all know what I've been thinking!

I don't like the center console in my 2001 either. I understand that with enough time/moneys anything is possible, but are the 2005 + console a direct bolt in?

It probably is coming out of the heater vents. There is a foam around the doors that open and close to direct the heat to the position you have selected (vents, floor, vents & floor etc). You'll find a lot of people on here, me included, that have the same problem. If you do a search there is...

Success! The car started with just a couple of revolutions after adjusting the IPQ. So far it has started well in varying temperatures. As I told Arne487, the car has much more pep now and is much more fun to drive. Thank you so much Arne487 for generously responding to my request for help...

Just remembered that I didn't state that I have to keep the CTS unplugged and to cycle the GP when cold, for the car to start as good as it does. With the new sensor plugged in I can't get it to start. Has anyone else tried this type of filter with the permanent tee? Did it work fine in hot...

Thanks for the fast reply craig01b! I'll try the o rings first. The filter canister doesn't look that old. Would it hurt to try this Beck Arnly filter with the permant tee in your opinion? I did try tightening the hold down bolt on the injector, but it was very snug already and I know they...

Hello Everyone: Please forgive this long post. I have already learned A TON of information by reading for hours on this forum. I'm now very frustrated and need some help. There aren't any local Gurus that I know of to help me. I know just enough about wrenching to get myself into trouble. I'm...