Search results

On my car I see a plastic ring along the internal wall of the orifice where the sensor goes in, it it normal? or is the reason why my original sensor does not goes in?

no picture need it, thank you 454k30, i knew it

come on guys, anybody with a mk4 tdi can open the hood and check for me please

[/url][/IMG]

Sensor

I remove the sensor to replace it with a new one, when I put the new one I notice a gap between the sensor wall and the block. I don't think its normal but when I put back the original the same thing happen, i try using a pry bar to push it more but didn't. any ideas?

I have two new gray 109 relays, test them both, also my glow plug light does come on.

sorry, yes i get fuel

I dont think corrosion but maybe a splice, i had the Evry Mod for a few months..

I did that all ready to all 4 injector lines, but no luck

i will check all the wires first and will come back

well i don't have a gp code, and the harness was one of the first things i replaced when i bought it oem

How about the glow plug relay? What happen if it goes bad?

I now feel that I have isolated the possible problems: Bad ECU or bad wires(corrosion, broken, etc), bad wires sounds better and cheaper, hopefully its that. Any specific relay besides the 109 that will make the car not turn on?

What worries me is the Fault code 01314 - Engine Control Module, I will check or remove the whole wire harness and check one cable at a time until i find the problem. I used the "Evry mod" for a while, maybe something happen with the wires or fried the ECU. Anybody have a loner ECU without...