Search results

  1. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    Many years ago, I had a fault for solenoid valve 2. I'd clear it and it wouldn't come back for a long time. Then it would reappear for no obvious consistency of conditions. I'd clear it. Then it started happening most often in winter months. Sometimes I'd clear it, let the car idle and warm up...
  2. MOGolf

    VCDS question

    Could you post all the fault codes found? Also, use the generic OBDII function to capture (and post here) the freeze frame data.
  3. MOGolf

    List of all sensors

    ALH engine (US market 1998.5-2003) has - coolant temperature sensor in coolant flange at left side of cylinder head - crank position sensor front side of engine block - fuel temperature sensor under the top cover of the fuel injection pump - mass air flow sensor at the air filter box - lift...
  4. MOGolf

    BEW TDI (A/T) Coolant hose identification...

    If you need the flange that has the larger radiator hose and bolts to the cylinder head it is part 038121133J, sealing o-ring 037121688, and o-ring 037121687. The 044121144B bolts to the 038121133J flange with 037121687 between them. Or do you need distributor piece 1J0121087C? Various hose...
  5. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    Obviously, the rubber bushing has failed. There does appear to be a crack in the bracket at about 10 o'clock from the left bolt in the bottom picture. The fact that no dirt/undercoating appears disturbed suggests that bushing took the brunt of the force and gave out thus saving the body from...
  6. MOGolf

    New B5.5 wagon with a problem

    "The injestor quantaties at idle appoximately had " 1: 0.16 2: -40 <---- really? negative 40? not missing a decimal point? A -40 would be way out of balance with the rest of them. 3: 0.0 4: .1 Also consider a diesel purge procedure to potentially clean out the injectors a little. Has this...
  7. MOGolf

    New B5.5 wagon with a problem

    It's a BHW engine. What do you see for injector balance values? Have you taken off the cylinder head cover and looked at the cam followers and cam lobes? Worn out? I know it you posted 130K miles, but if the previous owner(s) didn't use the correct oil they may have premature wear. And the...
  8. MOGolf

    Vagcom Source for 96 B4V

    The B4V was not a technological marvel. You need the VCDS Lite 1.2 software from Ross-Tech. It works with any basic OBD-II cable. Back in the early days, some of us actually built our own dumb cables and the early versions of VAG-COM (as it was known back then) worked great.
  9. MOGolf

    Boost Problems - Vibrating N75 - Low boost with engine cold

    The large tube connection with that tape over it is the main vacuum line. It is supposed to be loose as a relief for the engine vibrations. If it does leak from that location, the the vacuum pump should be replaced. Someone taped over it and over the course of time it has become oil soaked. The...
  10. MOGolf

    Boost Problems - Vibrating N75 - Low boost with engine cold

    You have a vacuum leak. Probably the large vacuum line to the brake booster. They have a history splitting as they age. This will cause the power brake issue and the loss of vacuum to the N75. You probably did not have a problem with the N75 until your attempted cleaning procedure. Now you need...
  11. MOGolf

    2003 golf tdi headlight upgrades

    I'd suggest replacing the lenses with glass lenses (Urotuning and other sellers) and adding Weathertech LampGard on them. You get the benefit of lenses that won't go yellow and are protected from stones, etc. I've had LampGards on all headlights of every car I've had for several decades and...
  12. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    Here's the wheel bearing procedure. The first two pictures show the sensor that I wrote about. They are ABS sensors, not brake pad sensors. Although the procedure shows the sensor attached to the bearing assembly...
  13. MOGolf

    What happens if technician installs oil filter element upside down?

    There is no spring in the filter. It might be marked with OBEN instead of TOP, if still legible. The plastic baffle inside the filter is there to keep the oil level up to that level when the engine is shut off. In a normally installed filter, the oil would flow out to in and up and then...
  14. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    As moderator for this forum, consider yourself warned. A post like that is not in keeping with the TDICLUB decorum. I may delete the post entirely. You have come across as inexperienced at car repair at least with regard to the B5.5 Passat. I also see a person who was anxious to get the car...
  15. MOGolf

    Oh joy... MORE fun!!

    A length of 2x4 with two grade 8 bolts through it.
  16. MOGolf

    06 Beetle TDI Fuel Filter Change (BEW)

    cp, You're welcome. I keep an old small hair dryer in the garage for use on heat shrink tubing when doing wiring repairs as well as thermostatic Ts and other plastic parts that need to be made pliable with a little, but not too much, heat. A paint stripping heat gun would do the job quicker...
  17. MOGolf

    06 Beetle TDI Fuel Filter Change (BEW)

    Use a hair dryer (or other suitable low heat source) to warm the T on the filter to > 100 F. Keeping the T warm, cycle the fuel pump on several times. The warm T will open to allow air to cycle back to the tank and fuel filter, tandem pump, and fuel rail in the head will purge from air. You...
  18. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    Rear axle beam bolts to brackets that bolt to the body forward of the rear wheel wells. Yes, you're probably better off not repairing and moving on from this vehicle, unless you really want to drive a B5.5 Passat TDI or get a better, realistic, number from the insurance company.
  19. MOGolf

    new to me 2005 passat wagon on a tow dolly . WELL THAT DIDN'T LAST LONG

    Rear axle beams from any front wheel drive B5.5 will bolt on in place of that. Not a hard job. Should be able to locate a used one. For the body damage, I've seen a lot worse cars on the road with damage just left as-is. You'd need to make sure the tire doesn't rub on anything once the axle...
  20. MOGolf

    //// 1990 Jetta ... we don't go back that far ! ////

    There is the "Other VW Group TD(I)s" forum here. We have covered older models. A certain 85 Jetta painfully comes back to memory. I think there's still a mark on my garage floor where is tinkled its brake fluid from the rear brake line that rusted through while undergoing timing belt surgery at...