just measure the thread with a caliper and see if its the same or not. if different forget about it.
also to machine the housing for the compressor wheel you need to have the drawing.
its easier to just buy an upgraded compressor wheel in the desired size from KTS , they will supply you with...
R70 cp3 modified should be able to do 350 with good enough injectors and fuel supply to cp3 inlet. Looking forward to seeing this maxed out with the new injectors :sneaky:
Im gonna start soon i hope a project of my own.. gonna be interesting for sure.
Electronic actuator ..no more vacuum stuff...
Avoid the dq500 if possible, heavy slow gearbox and pretty difficult to map. Been there , done that, regretted it
Dq250 does everything better for the power and torque you will make.
On the new engine 272hp we did 399hp with my hybrid setup on this car , gtd2060 upgraded to 2565 , DPF on.
Would of been better without DPF, less stress on turbo
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.