Sunday,05,February,2017,19:28:40:03812
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 17.1.2.0 (x64)
Data version: 20170127 DS267.1
www.Ross-Tech.com
VIN: AJ License Plate:
Mileage: 245260km-152397mi Repair Order: cont-output...
i've been working on this problem/issue for 6mo.
MY QUESTION:
How can i verify with VAG-COM that receiver is not working/dead or a security issue between the BCM and fob receiver.
Security adaptation codes needed?
HISTORY of ISSUE:
Six months ago i installed a new BCM because when you turned...
apologies
2012 golf
what i see is my shop #s are different
old Shop #: WSC 01357 011 00200
new Shop #: WSC 12345 123 12345
******************* OLD J519 ********************
-------------------------------------------------------------------------------
Address 09: Cent. Elect. (J519)...
i replaced my BCM and now fobs will not unlock doors or operate windows.
copied long code from old module.
spent $55 at dealer to tell me the keys are already programed. the suggested that i let them look into why the receiver isn't working
Lensdude_com
thanks for replying,
What steps have you taken to troubleshoot the problem?
pulled headlight connector checked pins for source V+ and found that turn signal wire is source of V+
Does the switch stalk activate the right turn signal? YES
Does your Emergency Flasher switch work...
my left turn signal lamp is continuously on, not blinking just on, key removed from ignition light still lit. i removed the 30A fuse to turn off lamp over night.
help
I've replaced my rear tail light housings with LED aftermarket housings. the lights on the body housings work correctly. the running lights and reverse lights on hatch work but brake lights don't work.
I'm including my long code from vag-com
how does electrical system work there's not enough...
I own a 2012 MKVI and installed rear aftermarket LED lights. the issue I'm having is that the LED brake lights on the hatch don't light when brake peddle is pressed. I've looked at VAG-COM elect-controler 09 and went through line by line to see if there was a code that would turn them on. no...
I own a 2012 MKVI and installed rear aftermarket LED lights. the issue I'm having is that the LED brake lights on the hatch don't light when brake peddle is pressed. I've looked at VAG-COM elect-controler 09 and went through line by line to see if there was a code that would turn them on. no...
ATA confirmaton disable
i have a 2012 Golf and this is what i did to disable that annoying horn.
using a VAG-COM and select 09-Cent Elect
then select "long code" button
then this step is important
COPY LINE 1 to TEXT EDITOR AS A BACKUP
FOLLOW THE ON SCREEN INSTRUCTIONS
arrow down to byte5...
this is on an 04 jetta... i replaced cmc in july because of same issue... brake fluid was changed then... clutch was replaced in January because of same issue...
the hight of my clutch pedal changes with temperature. when it's hot pedal is hi or so high that the clutch slips. when it gets cold, now at night 50F clutch won't disengage enough to put the car in gear.
i think its the clutch master cylinder or something restricting the fluid between cmc and...
car B4 1996 tdi
list of symptoms:
engine will run no issues >50F.
engine will idle only <30F if throtle depressed engine will stop or feel like only running on one cylinder.
once engine warm no issues!!!
checked glowplugs with ohmmeter all read 1.1-1.2 ohms.
checked harness 12+volts while...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.