It is a 5 speed, it is around 250 K, paint job is cracking and pelling something horrible. The door trip pieces have fallen off. I can get $500 tax donation for donating it. I'll stop being lazy and get some pictures
I have a 1998 TDI Jetta that I have not moved in two years. Two years ago when I was troubleshooting I could only get it to start after significant cranking (had to get EGT up over 200 before it would start). As part of the diagnostic process I tried to adjust the timing advance and found out...
I've had a small fuel pump leak, but I didn't do any thing about it until it was a good solid stream. I decided to change the timing belt and water pump at the same time. I followed the instructions at http://www.tdiclub.com/articles/A3-TimingBelt/ and at...
I just noted I have a hole in the top of the transmission, drivers side, looking from the battery. It is actually two holes that intersect making sort of a figure 8 shape. In the bigger hole I can see the teeth of a gear.
Should this hole be covered with part number: 02A301115A ...
Updated diagram
I know on my vehicle I do not need 800 mm of hose to go from the N75 to the air box since the N75 sites behind the fuel filter on the passanger side of the car instead along the firewall. However, I belive all the posted lengths should be more than adequate. The best policy...
Sorry I've been absent. I got busy and did some major work (front axles and ball bearings) without even inviting anyone to come hlep me curse, see http://forums.tdiclub.com/showthread.php?p=1961734#post1961734.
Hi bikeproof
jkenny, I'm in Los Alamos and I will be interested in a TB change in...
In November I replaced both front axles, wheel bearings and hubs on my 98 A3 Jetta TDI. Sorry it has taken me so long to get a lessons learned together.
Starting with the axles, I followed the procedure posted by Wingnut ( http://forums.tdiclub.com/showthread.php?t=138801 ) and even...
I plan on buying the tools in another 40 K miles to do my first TB job. I'm in an A3, would the tools be the same as other cars? Would it make sense to set up a NM Tool Swap / Check out? http://www.metalnerd.com/ has different part numbers for A3 vs A4. In socorro there is a great tranny...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.