Search results

Been too busy on other things bath remodeling, tore old shed down / build new one, had get one Jetta to pass inspection new DPF / remove subframe (so easy thank for write up oilhammer) took like 15 minutes get subframe down / 10 minutes to reinstall. and no front end alignment need flew to...

NO IDEA WHY IT SHEARED BUT MAY BEN OVER TOURQED I WENT TO BATHROOM AND CAME OUT BUDDY WAS CHECKING TOURQUE ( HAS WASN'T THERE WHEN i DID IT) I THINK HE OVER TORQUED THE PULLEY BOLT...

aporchmeduim said: I replaced my DPF myself. It took me 8 hours in my barn on a car lift. its really not terrible, just time consuming. If i had to do it again, id probably be a oil hammer has write up on removing entire subframe only takes 30 minutes (it went back up in like 10 minutes) it...

thanks

just replaced DPF in my 2014 JSW had codes 202 / 4??? i fogot, plus tell tale soot in exhauset pipe. all down, but still need tell it via VCDS that car has new DPF I don't know how to do that ? any body know? thanks.

had put project on back burner, lot crap going on...started rehabbing bathroom, been taking showers at my sisters, few days later found rear door and also garage door kicked in in attempted burgerly.. but they couldn't get in, but I had to replace both doors and frames!, my other two Jetta...

its not clogged its cracked. all you can do is delete it or replace it

not that im familur with. RawTech gold standard of quality welds / workmanship.

Rawtech can't ship to USA any more, I have stage 2 Malone tune and DSG tune runs great but my DPF is cracked this is 2nd. last two were replace by VW at 90K and the replacement failed after 13,K miles but VW only warrenty them for 12K so I'm such out luck I live in emission testing area...

there's only like 1mm wire to work with both wires given that I only have one hand its too much trouble to hold wire etc. easier just to replace harness

broke Eletronic stability wire at left front wheel my JSW..after replacing DMF :mad: now got find new harness

that's what I do, work few hours till it get hot / humid, then quit (I am working in my driveway..) just finished 2nd DMF install in a week on 2011 JSW (friends) and my 2012 JSW just after finish it, test drive Electronic stability lights illuminated..found wire completely broken at left from...

I got a 2nd JSW to use as Oklahoma blue print if i need know where something goes...

I live in st. louis area where emission are required my buddy lives in no emission area im going register it at his farm

I've already started on removal of old engine

I'm enjoying it, 6 years one company and then 28 with company I retired from... I asked that question, too but they (the service advisors) said they'd only use their supplied engines, wouldn't take on work, unless I paid for their supplied engine. $8+k is lot for engine & labor, but when I...

which is easier? swap old injectors in or put s/n to new injectors in? yes I have VCDS

I have 2014 JSW 6 speed manual w/ 2.0 CJAA tdi engine. Last year few thousand miles after timing belt replacement bolt on big idle pulley sheared... engine junk. Car-Doc / oilhammer / Brian Johnson shop quoted me over $8500 to replace and they wouldn't accept customer supplied used engine...

bought a used TDI of seller that bought it at auction due DPF code. had 161K miles out of the dieselgate warrant. it now has 171K miles seller removed DPF installed Bussken down pipe.. and said it had stage one malon tune. I'm begging to think seller lied to me about stage one malone tun.. as...

sent you a pm