Search results

  1. A

    WTB TDI ALH engine wiring harness

    The small harness from pin 82 to 121 going from ECU to some engine sensors. Its for a 2001 Jetta.
  2. A

    MK4 Jetta ALH no start condition Intermittent

    Hello : Here's my codes after the scan : *17655 – Needle lift sensor (G80) Open or short to Plus - P1247 – 35- 10 Intermittent *16706 – Engine speed sensor (G28) : No signal - P0322 – 35 – 10 Intermittent *17654 – Needle lift sensor (G80) : Implausible signal - P1246 – 35 – 10 - Intermittent
  3. A

    MK4 Jetta ALH no start condition Intermittent

    Hello, I have the same issue on the same car since 1 month. Also, since I have this intermittent no start condition, my glow plug light is always blinking when running when it starts ok, but runs fine. Sometimes (very rare),, the engine missed one entire révolution on highway, but never...
  4. A

    TDI ALH crank but not start (intermittent)

    Hello, I have a 2001 TDI ALH and since 2 months, i have this problem : -sometimes the glow plug light is blinking when running but it runs ok. -and sometimes it crank but not start (same if warm, cold, operating temperature...). IT could not start at all after cranking 5 Times, then starts fine...
  5. A

    Tdi alh 2001 2-wire glow plug séquence?

    On my alh, im wondering if the pin 4 of the 7 pin relay and the pin 6 of the relay go respectively to cylinder 1-2 together and 3-4 together ? Or maybe 1-3 and 2-4? Is the order important or the ecu power the Glowplugs in the same time ?
  6. A

    Toyota motorhome swap tdi alh?

    Someone have tried this conversion with a 21ft toyota motorhome ? What could be the gas mileage numbers ? Is it possible to travel 55mph on flat roads and Go up Hill at slow speeds? Discuss!
  7. A

    Starter for a Audi A4 TDI Quattro swap with 1.8t M/T

    Will this starter fit ??? Will the starter crank more than the 1.8t one? It have to fit on my 1.8t quattro manual tranny too. : http://www.ebay.com/itm/ANLASSER-STARTER-FUR-AUDI-80-90-A4-6-SKODA-SUPERB-VW-PASSAT-1-6-D-TD-1-9-2-0-TDI-/331324576486?pt=DE_Autoteile&hash=item4d247bd2e6
  8. A

    Wiring diagram Jetta 2001 (A/C and cooling fan)

    Anyone have mitchell on demand or Bentley with the wiring diagram for A/C and cooling fan for a Mk4 Jetta?
  9. A

    Audi A4 TDI swap : electronic accelerator pedal

    Since 4 years, I like my Audi A4 TDI ALH conversion. But there is a problem : I changed the electronic accelerator pedal (TPS) 4 times in 4 years... What I've done to swap : I removed the cover with the potentiometer from a Jetta TDI pedal and installed it on my Audi A4 pedal. Worked fine and...
  10. A

    De cossé vous faites dans vie ?

    La 389 est rendu moins pire un peu que dans les années 80 mais est quand même toute une trail a pratiquer... Les côtes glacées l'hiver et la planche à laver l'été. Mais juste la 138 en B-train l'hiver peut être usante au fil des semaines et années. Mais la difficulté est pas un prétexte, le...
  11. A

    De cossé vous faites dans vie ?

    Après 6 ans de loyaux services comme conducteur de camion citerne (secteur pétrole) je tourne une page, comme Torque Delight, pour me trouver quelque chose de plus motivant et plus épanouissant, sans compter un horaire plus léger et moins fou, donc réorientation de carrière! De toute façon, a...
  12. A

    ***À Vendre*** Édition Janvier 2014

    INTAKE DE PD150 : 150$, localisation Quebec mais possibilité de shipping.
  13. A

    ***À Vendre*** Édition Décembre 2013

    J'ai quelques pièces aussi et je voudrais faire de la place, les billets verts prennent moins de place! -Intake de PD150 : 175$ - Photo a titre indicatif c'est celui du bas -Porte arrière droite Jetta MK4 bleue foncée avec trim intérieur : 40$ -Courroie serpentine contitech neuve de ALH avec...
  14. A

    TDIFest 2013

    Good!
  15. A

    Bearing de roue - dangereux?

    Avec un vieux kia, j'ai pogné un bon trou un moment donné, mais rien de si impressionnant. Avant de pogner le trou (genre 20-30km avant) j'avais fait le tuneup et les bearings etaient beau, pas de lousse du tout et aucun grondage. Ça s'est mis a faires des gros TOC bizarre et faire un bruit de...
  16. A

    Project GTB1756VK, tubular manifold and water to air intercooler!

    The efficiency of the water to air intercooler is impressive! The IAT temp do not rise even if you accelerate 50-60% for 10 seconds! But if you accelerate really hard, IAT will raise 4-5 celcius degrees, it's respectable. You just need a lot of time to make the water cooling in the front...
  17. A

    ***À Vendre*** Édition Mai 2013

    Intake de PD150 : 200$ , possibilité de shipping
  18. A

    Custom cold air intake sounds too loud, any advice?

    The air box is too big, with the 1.8t there was a very very little turbo and the airbox was very close to turbo yet. Now with the GTB1756vk and air-to water intercooler, it's impossible to fit that. Even a Toyota Tercel air box will not fit, not enough space.
  19. A

    Custom cold air intake sounds too loud, any advice?

    I'm unable to fit the OE setup because it's a audi a4 tdi swap and I have no place at all to fit it. The cone air filter is located on the bottom of the bumper grille and it go to the intake. There are a complete splash shield installed to prevent water getting sucked by the engine.
Top