I have two sets of window regulators with speakers and one set of side window glass for B5 or B5.5 sedan. The rear regulators my fit wagon, but for sure the rear glass won't. Pick up near Little Falls MN. $10 for each piece. Also some other Passat stuff like side mirrors door latches, and a...
I've used a 14mm deep well socket for an alignment pin. Never had any problems, but I always check first before removing subframe bolts. I also use a pick to score the supports in front to help put the subframe in the exact same spot as it was in.
If you start hearing rod knock, don't worry it won't knock for long. (That's because there will be a large hole in the block right before the engine locks up).
Yes, it can be used with stock 1.8t DMF flywheel. This is the same setup that Levi used in his video on "Passat Manual Swap" I'm curious how this setup has worked for him.
I agree, the plastic busing that sits horizontal near the golf club on transmission sometimes gets corroded. I've had to clean up two of them. I needed and air hammer to remove them. Once cleaned up and greased the transmission shifts way easier. There is a Youtube video on this but a can't...
I've seen a few videos and a write up on Motorgeek where people have converted Audi AWD cars to RWD by welding up the gears in the center diff of 01E. They did this so they could go drifting. I don't know how long the trannys lasted after that.
016 is is 5 speed Manual transmission used in many gasoline powered Audis (mostly Quattros, but some front wheel drives) O1E is commonly a 6 speed used in later models of Quattros. It would be nice if you could locate a manual transmission that was geared properly for a rear wheel drive...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.