Search results

PLEASE LET ME KNOW IF ANYONE HAS SOME MUDFLAPS THEY WOULD LIKE TO SELL. THANK YOU

I always use ATE rotors and pads front and back. Produce a bit more dust but perform great and durable enough.

Ciao!! BRAVO!! Lavoro ben fatto e grazie per il video. Ogni due anni io vado a Maida(CZ) da vedere i miei. Tantti Saluti!

Thank you CoolAir and 454 for your advise. Looks like I'll be heading to the muffler shop.

Exactly!! Thanks GForce. This is EXACTLY what I was describing in my post. My clutch seemed to function normally but clutch began to slip gradually more and more over the span of approx. 5K miles until finally could barely pull the car on a slight graded road. Could somebody elaborate how this...

Broken Stretch Bolt Same thing has happened to me. 1 of the 3 horizontal stretch bolts has snapped. Does anyone have any advice as how to remove this broken bolt?? Is it nessesary to weld a nut to broken bolt for removal or does somebody have an alternative method? Only have about 5mm of...

Looks OK. Would something like this be caused by running the clutch too thin?

Hello. Just removed my transmission for a new clutch. There is evidence of grinding below the main shaft on the tranny housing (protruding circle with 4 nuts near each corner). Has any member had or seen this before on a A4 tranny? Not sure if this is cause for concern or not! Please chime in if...

Vag PM Sent

Jetta wagon hitch I have an excellent condition Curtis hitch from my 03 Jetta Wagon if your interested. No rust at all (California). Less than 2 years old. Used once for light towing. Good luck

200,000 miles My 99.5 jetta sedan 5sp just did it with all original parts. Just the usual little quirky things! Love this car!

200,000 miles Just turned 200,000 miles on my 99.5 jetta sedan 5 sp. Everything is still original. Just timely maintenance and an alternator at 110k. Always get 730 per fillup. This has been my favorite car to drive. Puts a smile on my face every time. I'm looking into a 6spd manual passat to...

Nitrile I keep a pair of Nitriles stuffed in right above the gas cap so when I pop the gas cover, they are right there waiting to get oily! After using I put them back in the same place and continue to use until they develop a hole and then discard. I could usually get about 5 refuelings per pair.

Ecuador I would like the ECU please!

Seats I'd like the front seats please if still available. I live in Los Angeles for pick up. Please email me your phone#. Thank you

Same with mine! After I replaced injector #3 due to code P1245, no more engine shake.

I used a light coating of Elring sealent on the o ring and it's held up fine for the past few years. Good luck with it!

Ooops! Sorry about that! Lets try this again! Thanks COMPU 85 http://forums.tdiclub.com/showthread.php?t=132193&highlight=needle+lift+sender

Is this it?? I had the same problem and this link helped me a lot! We should all be thankful for such a great group of people! :D http://forums.tdiclub.com/showthread.php?t=369772

Thanks Timmy. Solenoid is on the top of the starter. Could it be replaced without removing it from the car?? Thanks again!