Search results

I been busy I not had time to troubleshoot overheating issue. Completed an head gasket leak test. Negative! I noticed water flowing in the expansion bowl but sometimes stopped. Top radiator hose hot, bottom cold. Was not sure the gauge was working correctly, so I purchased a scan gauge. Scan...

It shouldn't be. It is only two years old. When I recently had IP pump rebuilt, I removed radiator to get to the timing belt. Maybe its the gauge

Removed the connection from the fishbowl and water is flowing so that elminates the pump being bad.

I have another issue, it is running hotter than normal. Looking inside the rad, it appears the water is not moving. The top rad hose is hot and tight, the bottom is cool. The temp gauge is displaying 210-215. Water pump has about 28,000 miles on it. I replaced the thermostat since that is a...

Are they as good as Bosch? Dang you think these things would be bullet proof. Once they go out, you need a wrecker. I was yesterday, I made it back home but that afternoon, I tried to start and no start. Dead in the water!

I added 2 gallons to the new tank thinking is would run on that until I could fill it up. That is why it was getting air. Added tw0 more gallons and problem went a way. Does anyone know where I can get a Bosch crankshaft sensor? This engine came out of a 2002 new beetle 1.9TDI. I replaced the...

I will give a try and let you know. Do you still think that I need to put a resistor on the line?