Thanks Everyone! I was able to source an engine from a forum member. Providing it's a good engine I should be good to go. Thank you!
In need of a long or short block. If rebuilt would prefer it to be a full proper rebuild. Can be a used setup but not from a runaway or broken...
FS: 2006 Jetta TDI Fully Loaded $6,000
Price Lowered!!! $6,000
Timing belt just changed.
Car is Sea Green Metallic 250,000 miles and fully loaded. Has black leather interior good working heated seats. Dual climate control with air conditioning that blows strong and cold. Body on the car is...
transmission, axles, and spindles sold. Shift linkage and pedals etc etc still available. $400 obo.
Ok I have for sale an auto to manual swap proposition. It's a little odd and maybe not complete but it would be close.
shift linkage (with dg short shift kit), clutch and brake pedal, clutch...
title states it all. I'll come pick it up within a 400 mile radius of 44446
Given notice I'll even remove it.
I will not pay more than 500 cash for it.
If you have one or know someone that has one let me know.
Selling my 2000 Jetta. Motor was rebuilt with rosten rods and pd150 pistons has ~30k miles on it.
Everything is stock, minus DC stgIII clutch and internal pistons/rods. I'll post pictures tomorrow.
Body is still in good shape but the paint needs some TLC, especially the roof. The clearcoat...
Selling my McNally Boost/EMP gauge and Oil Pressure/Temp Gauges with wiring and sensors for $500 shipped. Note this doesn't include the pod mounts, just gauges/wiring/sensors. The Gauges were just recently (last 90 days) upgraded to the Series II gauges and were calibrated/cleaned. The kit is...
Car is no longer a Feeler, but for sale $4,500 FIRM
The run down:
1. Head rebuilt by franko6 (Preventative maintenance car was running fine before and after head replacement)
2. Vr6 clutch installed last 15k miles
3. Timing belt done last 15k miles
4. Rear axle bushings and LCA...
I have the front two calipers off my 2000 TDI 40 bucks each shipped or I'll bundle them both for 65 dollars shipped.
I also have the caliper brake lines for the front I'll sell those for 10 bucks each shipped or 15 for both shipped. OBO
I also have the kerma TDI vnt17 adapter...
So, let a buddy of mine take the car for a drive.
Long story short the car wasn't at NOT and he stood on the throttle at 1,300 rpms. The turbo overboosted at whch point he still didn't remove his foot from the go pedal and the turbo surged then completely stalled starving the motor for air...
Up for sale:
jetta city fender liner like seen on idparts.com mint shape barely used 40 bucks obo shipped anywhere in the US. - sold
Front driver side spindle WITH the abs sensor, bearing, and hub assembly 60 bucks shipped anywhere in the US (the bearing has about 20k miles on it). - sold...
Can anybody help me out here??? I need the driver side heated seat cover. Just the bottom cover is all I need and nobody seems to have any heated seats anymore *sigh*
Also, anyone with a 2000-2001 ecu for a reasonable price (people are really high balling these things latley :rolleyes:) let...
Need a ARL, ATD, ASZ, AXR, Beveled wrist pin for (PD150 Pistons)
Are also found in the American PD BHW, BEW, BRM.
If you got a destroyed pistons with a good wrist pin or have one laying around let me know!
Edit: If it's a PD piston and it's beveled it will work as far as I understand!
Well last summer I installed an Oil cooler and fuel cooler in my car. I've had mix results with the whole thing. My fuel is definitely cooler by 15 - 20 degrees on any given day. But, my oil seems to not only warm up faster but it seems like the oil actually runs a little warmer too (this...
I did a little searching around and can't seem to find anything covered here on the ALH oil pumps and their assembly / specifications.
Franko6 gave me a short run down on how to disassemble the oil pump and to check the gap between the gears on the pump after the teeth meet. However, this was a...