I just took the hose off the egr and was not bad looking into it from the hose removed. The vacuum hoses look terrible. they need changing for sure. I will try to find info to check the vanes. this is acting like the vanes are closed and not air is getting in to run the motor. If the vanes are...
This car is not just low on power but no power kinda just hovers at
1200 rpm max extra smoke out of the exhaust. Not sure why this all happened at the same time the belt for alt ac ps. I do have to say seems someone had plugged the exhaust.
He came by but he was only concerned with the plug on the MAF MISSING THE CLIP LOCK, he wanted me to put a plug I had on a dead motor and didn't really have time to work on it.
I put the VCDS on the car and got no faults other than door lock and intermittent low signal to airbag, internal control mod memory error for ABS.
this is what showed on the vcds
I can not understand how the timing can change, AND should I go and adjust the timing at the timing gear to...
flee, that was a great offer from you and I sure do appreciate it. My boy dropped off the Vac com that he borrow from a friend. Now I will have to watch some videos on how to use it. I do plan to check the timing and see if it is in range. What else do you suggest I check if I can figure out how...
I did write the fellow from Oregon back. I thought he had sent me a private message so I private messaged him. Yes I am in Agua Dulce and it is just in the 70 miles range and I can put it on my trailer to move it or AAA.
I do not feel like trying a timing belt change out if I can get get someone to do it reasonably.
the timing belt looks ok from the top does not run correctly accessory belt off. I want to thank all you for your input, the only time I have seen such a helpful group was when I had my 1962...
I will have to see if the manual tells how to check the static timing, I have never done it. Is there a quick and dirty method to just turn the crank and look for some alignment marks.
no wires were damaged, not sure on the pump timing, I was only able to scan it with a bluetooth scanner in the obd port. The first time I scanned it when it first happened there were more faults but they did not show when I got it home and redid it. and I did not think to snap a screenshot at...
Here is what happened, I was on the freeway and all is good and all of a sudden I lose power, coasted off the freeway, serpentine belt is broken and hanging on bottom of motor. check the pulleys to see if any are bound up. all turn but the idler pulley at the bottom is a little tight. replaced...
needed a starter for my toyota, had it rebuilt and working good the rebuilt I put in my tractor from the same guy still going after 12 yrs. oh the started cost lest to rebuild then the one from autozone.
I bought a radiator for my 98 2500 tdi, I was leaving on a vacation in 3 days and that was the only place to get one. I do have to admit it was about 1/2 the weight of the old one. but fit perfect and got me on vacation. maybe 5 years later in went out again. and they replaced it free. all...
I have only about 8,000 since the cooler and codes and issues not one since the cooler I did do the line pressure increase with the torx screw in the inside of the trans for stronger tighter shifts as well. cross my finger and enjoying the drive. 110 degrees today 185 on the trans oil.
My auto started to act up added a external cooler and with over 100 degree days it will run up to about 180 and since the cooler. no codes thrown and never has acted up since the install. all is good now.
I agree. I bought an 01M 2002 136k the trans started to act up I added a trans cooler to it (would go to 240 degrees) It now runs below 180 degrees in 100 degree weather we are having here near you in Agua Dulce. and has not showed any bad signs since the cooler and maybe 4k miles. I will go...
this stuff is for bearing press fitting may work BUT temperature could be an issue if it is very hot.
http://www.ebay.com/itm/111984392551?_trksid=p2060353.m1438.l2649&var=410925452181&ssPageName=STRK%3AMEBIDX%3AIT
exact combo I have 2003 5 speed dead motor and 2002 auto. But I just did a transcooler on the 2002 auto and that thing runs cool and without any sign of issues for now. but I will listen to the input. I think you need to do some work with the glow plugs for the 5 speed as well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.