Search results

hello ! Anyone have any idea of this turbo? the turbo is ball bearing. in exhaust it's F10 bmw.

Hello ! I will soon install an MFD screen. But i have to make a harness to test by VCDS and check the good funtioning of the cluster. I tired a harness but it dosen't workk with VCDS. I have connected the CAN H and L confort and motor. It's a cluster IBIZA 6L it's same POLO 9n. You have a idea ?

Hello you from Réunion Island 😅 Its a golf mk4 pd 100 engine Adt

Hello !! the clutch pedal has been soft for a while. I pump the pedal back to normal. I have already changed the master clutch and slave cylinder. of course I have already done several purges. To purge I use a device which puts under pressure the circuit but no leak appears. on the other hand, I...

Sorry but there is nothing behind headlight Switch

there is nothing

I don't have immobilizer at least I can't find it. may be the european car because not this type immobilizer. on the other hand I more or less find the breakdown either it is ignition switch or connector.When i move the wire the engine start and sometines no start. Somebody have a schematic...

Yes i replace the filter by a New. Its golf 3 ahu. If its immobilizer you think its possible Shen same with a fluid start engine ?

today i tested the pump in the tank. i used a pump to see if its sucked fuel well. I think this is good what do you think !

Nothing, I am one morning I park afterwards to leave the engine don't want satart. I finish change i replace by a new filter. It's 90hp

i have already check on the harness just wire: -shutoff selenoide. there are 12v and i even removed the piston small inside -CKS sensor 1,2k ohm about

what do think the timing

yes i used timing marks and use tool specific engine. yes there are not pump in tank. and i have good fuel at each injector when the engine start. when the egine start with cleaner i eliminate: -The immoblizer -ECU -CKS sensor

i checked CKS sensor it's about 1.2k ohm

i ckecked the timing but i did not ajust the timing with VCDS but I don't think it prevents her from starting. I not have tool for compression.

hello !! my car no want start. The engine only start whit cleaner, if i turn off it's impossible start. I have already check: - vagcom no code - relay 109 it's ok - Pump selenoid it's ok 12v on - I tested a new pump (engine always no start) - I tested all injector (engine always no...

thanks!!

there are two eprom H and L. If i want upgrade the ecu, i must change eprom H and L by eprom AM29F010 ??

for two eprom??

ok thanks! if i was good unterstand the post all eprom AM29F010B it's good for this ECU ??