Search results

I guess a razor scraper for the gasket and what do you recommend to remove sealant from block and pan? The two bolts at the RM seal came out OK and will get new bolts all the way around. Thanks for the advice!

I'm having trouble finding a link for the proper way to stop my oil pan from leaking. It has a gasket and is leaking from the timing belt side and doesn't seem to be wet around the front main seal. The wind is pushing it on the passenger control arm, steering rack and wheel cover backside but...

I'm looking for a High Output Altenator to work with my upgrade stereo system. Looking for something over 180a and I'm using a 120a which isn,t enough, because the lights are still dimming, I've upgrated all the grounds and positive wiring33333. There are company's that make these but don't...

How do I go about getting a 180a Bosch for my 00'beetle Tdi Part#

Yes! everything was replaced pertaining to the clutch, I might have 70 miles on the new clutch.

I ordered a new slave cylinder, maybe the original one is worn out and not strong enough to fully disengage the stg2 clutch. I will update with results, just hoping the tranny doesn't have to be removed.

I have a 00 tdi beetle 5sp with new daily driver clutch (stg2), car was driving and shifting fine, then one day when pushing clutch in to shift, car slows like brakes are lightly applied then hard to shift at times. I'm confused why this is happening.

Mine broke where the top of it connects to the cap, the shaft fits tight in the MANN oil filter hole and probably broke due to unscrewing the cap for an oil change and did not notice any missing pieces where it came off. Anyone else having this issue? I notice the shaft turns freely.

Thanks everyone for the advice, i'll get back when all is said and done.

I have a VNT17/22 with a PD150 (OMI) and need a Flexi Pipe to the MAF, the OMI has a larger opening. Do you know of any place that makes a reducer flex pipe (OMI to factory MAF) Sorry for the confusion.

I I don't know much about the (24v VR6 A4), are you saying, in order to use the PD150 intake, my factory airbox and MAF needs to be replaced with the (24v VR6 A4) if so, what year and model will fit my beetle and any modifications needed to fit?

I installed a PD150 (Turbo Intake Pipe) on my 00'ALH beetle, but the factory Flexi Pipe/Accordian will not fit the PD150 (Turbo Intake Pipe). The PD150 opening O.D. is 3.10" to the factory MAF. Any suggestions what to use

PM... on the PD Lift Pump.

Hi everyone, I'm needing a Ignition Wiring Diagram of the 2 wires that seems to be the culprit of melting the plugin to the ignition. I upgraded the power wire from the S176(110A) to the interior relay panel with 2ga ofc, the S177(150A) to the alternator with 1ga ofc , all this fixed the...

Do you recommend the dvd or orange or white hard back?

Where did you get the power source from?

I'm wanting to attach a ECS ES#: 2506723 turbo-s frt bumper to my 00'beetle TDI. I need a list of parts and step by step instructions. Your help would be appreciative!

The pictures show a jetta not a beetle in the instructions.

I'm upgrading to an IP 11 and electric lift pump on my 00'beetle. I purchased both BEW/A4 lift pump and wiring kit from ID parts, the diagram is for a Jetta, not for my beetle, need some instructions for the wiring and relay location.

Yes! with the stage 2 colt cam, INA Black Nitride Cam Lifters/ Followers and Dual Valve Spring Kit.