Search results

The wire harness is not included at his time. Included is engine complete with intake manifold (EGR Equip), Exhaust Manifold (turbo equip), original Inter-cooler and piping along with intake is optional.

Bump Bump Bump

How much are we talking about and what condition of an engine? Shoot me a PM with details if you want,

Looking for a ALH engine any condition preferably a complete engine.

I have a completely stock 1Z/AHU engine ive owned since origin as original owner along with intake manifold and EGR setup bolted on, along with turbo with "ZERO PLAY" currently sitting. Recently timed and water pump replaced ready for install. Motor has high life and ran majority of life its...

I have a AHU i just pulled all together with intake and turbo with absolutely no play!

PM sent

Did you post any information about the car???

Long delay. Finance n time pushed back. Finally mounting up part hopefully over Christmas break. ill be doing this all with the block on stand first.

Ordering Nural HD's soon. unless some one can suggest a cheaper, more efficient crown with the least possible squish on the top crown with lowest CR w/o sacrificing concentration of combustion.

Yeah, i gave up on the breaks for now and am working on the engine some more. Ill post updates when i get them.

wait i'm confused, The Nural pistons are stock for a different engine than the AHU vw. But i dont think their from a PD?? Can some one clarify the difference on ASV, BHW and Mahle pistons. I know ive been looking at the NURAL pistons due to a improved number of features compared to the stock...

PS, Drive shafts were fun. Any one needs a hint. 12point star and a hammer is the best investment ever. To bad the 50 people i asked before and as i was doing it didn't have this advice :/

Advice on cams, who & where?

still got it?

Starting Engine Overhaul, Advice and recomendations are welcome! Ok so here is what im doing. This is an engine rebuild so any one that has information on engine rebuilds of AHU engines please advise me or direct em to a different thread if you have good step by step advice. Below i will list...

lol, thats deff what he would say

So any way im going ahead with pulling it starting this saturday and will try and take pics along the way. I think i might make a new thread if i dont get many replys by saturday. Any one who has pulled the AHU engine and done a full engine rebuild I could use your advice and direction to any...

Um, that was a bit of a typo lol

Ok so here is what im working on for the engine. I ahve the 3bar map sensor. I have a VR6 MAF I have .205 injectors unpop tested. I have a VNT 17/22, i have a PD150 intake manifold that bypasses EGR, and a larger FMIC, repiped with hand made bungs for sensors. For monitoring i have a long EGT...