d0u8l3m
Veteran Member
So I had some time today to modify my dash to fit the Silverado cluster. Just some trimming with a hot knife to prevent making a mess with a dremel, so the cuts arent the cleanest but I think it looks pretty good. I got it sitting at the factory angle too =D
Some cuts on the lower part of the dash.
Gonna either epoxy the factory tabs or some 3d printed mounts to keep it held in place (though the surround holds it still once installed)
Final result
I also went to visit my grandparents in PA over the weekend and scored some sweet aluminum side steps (nerf bars/running boards?) off a ZR5 we found there! only $21 too!!!!
Some cuts on the lower part of the dash.
Gonna either epoxy the factory tabs or some 3d printed mounts to keep it held in place (though the surround holds it still once installed)
Final result
I also went to visit my grandparents in PA over the weekend and scored some sweet aluminum side steps (nerf bars/running boards?) off a ZR5 we found there! only $21 too!!!!