Seatman's latest activity

  • Seatman
    Seatman replied to the thread A3 1.9tdi wont start.
    Check the little wire is plugged in on the solenoid, small round part on the side of the starter motor. Might be disconnected or the...
  • Seatman
    Seatman reacted to Mr Jones's post in the thread No power with Like Like.
    Thank you..yes it was broken wires in between the back door and the pillar, took a picture but can't seem to load it up for others to...
  • Seatman
    Diesel was £2.05.9 per litre today at one shell garage! Don't know why they're allowed to have 0.9pence, not like they're going to give...
  • Seatman
    Seatman replied to the thread HELP.
    Smell the oil, if it stinks it might be gearbox and something has gone wrong there.
  • Seatman
    Seatman replied to the thread Clunk when releasing clutch.
    Yes, just that one, hard to point to things over the Internet lol
  • Seatman
    Seatman replied to the thread No power.
    Maybe a broken wire in the loom or bad module. I'd check the wires and swap the window module over if need be.
  • Seatman
    Seatman replied to the thread Coolant / fuel gauge not working.
    Try reseating the plugs on the cluster, I had one making a bad connection. I've also pulled the cover and used a small knife to make the...
  • Seatman
    Seatman replied to the thread Throbbing Noise!.
    Never damaged a hub yet, works every time. Just got to go careful but a grinder is best, not sure the dremmel will do it
  • Seatman
    Seatman replied to the thread Throbbing Noise!.
    I grind one side till it's almost through then crack it with a chisel. Then it just slips off
  • Seatman
    Seatman replied to the thread Clutch pressure issues.
    There's a little restriction valve in the clutch line of the Mk7, maybe it's causing the issue. I've read a number of people removing...
  • Seatman
    Seatman replied to the thread Whining Noise and Lots of Smoke?.
    No not really needed, just makes it easier in the future or something because the original feed pipe is solid so can be awkward to move...
  • Seatman
    Seatman replied to the thread Clunk when releasing clutch.
    I think you will need the ball joint off, otherwise you have to yank the cv into an abnormal angle to fit it in with a risk of one of...
  • Seatman
    Seatman replied to the thread Clunk when releasing clutch.
    That happened on my golf when I had it, made a hellish noise on corners lol. For the ball joint just hit the hub carrier around the...
  • Seatman
    Seatman replied to the thread Clunk when releasing clutch.
    Disconnect the main bolt of the ball joint and leave the 3 13mm ones alone then yes. There's room for movement with those 3 smaller...
  • Seatman
    Seatman replied to the thread Clunk when releasing clutch.
    Yeh bud, rev it in neutral then let the revs settle, you often hear the clutch rattling as the revs drop. But tbh mine was kaput and I...
Top