So after some searching the part numbers for a 1.8t and and alh are almost the same. Alh is 06B115251 and the 1.8t is 06A115251. So is it just a height difference. I cut some off the coned part and got it to fit but it's only 1/8" on one side and 1/4" of clearance on the other side. I can trim a...
I feel kind of dumb after that. Thanks. Next problem is my two piece alh pan is too short is hitting the oil pick up. Do I just have to change out the oil pickup tube. Moddify the lower steel pan? I split the pans and just installed the upper pan.
Ok so I’m having some issues. I’m to installing the oil pump but the bolts supplied from id parts work in two of the holes but the rear most hole is blind and the bolt bottoms out before it gets tight. Anyone else have this issue?
So I'm in the parts gathering and disassembling phase. Just bought parts to do the cam, timing belt and bs delete. Also bought the adpator from diesel conversion specialists. I liked them because they use the oem flywheel. Getting ready to pull both motors coming up. My question is can I use the...
Thank you. I have a new cam, timing belt, bs delete and timing tools in the cart. Anything else you would change while I'm in there. I'm pulling the motor out to stick it in a samurai so everything is easy to get to.
So I have bought a 05 passat with the bhw and I'm planning on doing a new camshaft and balance shaft delete. Do you guys here have supporting vendors or where should I get the parts from. Also I'm planning on putting this into a samurai with a toyota w56 trans.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.