Recent content by Divakaran

Hi Dan - yes, i replaced the metering device with new one and the same situation. the pressure regulator and pressure sensor both good. but VCDS is not showing any error. anything further i need to check. thank you and greetings for the CHRISTMAS

Hi Dan greetings. do you have any other suggestion to check

Dear Dan - Good morning and thanks for your response during the weekend. I appreciate. i checked the PWM signal cross the N290 connector while cranking and I am able to see the light blowing but the light is very dull not bright. However I was trying to check the N290 ohms but unable to do it...

Dear All - hope all should be having great weekends. problem statement is my car is not starting. it had flat battery and was standing for a while on flat battery. I recharged them and connected it back and the car started fine, it was running fine for 15 minutes and then stopped and from then...

Hi All good morning and hope all will have great plan for the weekend. I am back after a some medical situation, my car is having the same issue. the car is not starting, batter was flat and i changed it after charging. the VCDS is not showing any error however the car is not starting. initially...

hi my car is using UDS protocol and i am not sure whether i can be able to find the torsion value? can you please help? my temperature needle in the dashboard is extreme right in red when i switch on the ignition and the radiator is started running. no error code in VCDS and battery are good...

hi - can any one help by sharing your views and advice. me too have the same issue however i did not changed anything yet. i connected my VCDS and did a autoscan but unfortunately no errors. checked the fuel pressure from fuel tank, and the electric pump to HPP and all within limit. the...