Recent content by Az.Nick

  1. A

    Brake pedal pulsation, not warped rotors.

    Gents, So I checked out the car this a.m. and after inspection I did notice worn LCA bushings in the rear, which I ordered the kit. While road testing the wifes car again, I noticed the following; When braking for a stop I have normal pedal no issues, when at 5 mph or less the pedal will get...
  2. A

    Brake pedal pulsation, not warped rotors.

    Thanks, I will inspect for the items you listed. In your repairs have you ever had the LCA bushings #3 trigger the abs or make the pedal pulsate?
  3. A

    Brake pedal pulsation, not warped rotors.

    Installed new wheel bearings 8 moths ago; Will check the connections for rust & harness conditions as well. what should be the proper wheel speed sensor clearance to the tone ring?
  4. A

    Brake pedal pulsation, not warped rotors.

    Not sure what happened with the previous message but here is the rest of it; csstevej said: Have you checked the LCA aft bushings yet? Jack up the car and grab the control arm and move it fore and aft , is there movement? Are they broken ? I had that issue on my daughters car. You can always...
  5. A

    Brake pedal pulsation, not warped rotors.

    I will get it in the air tomorrow and check for any movement. Did yours pulsate due to
  6. A

    Brake pedal pulsation, not warped rotors.

    I had a previous rotor/steering vibration due to warpage and had them turned along with new pads. Seems to be 2 separate issues unless I'm missing something.
  7. A

    Brake pedal pulsation, not warped rotors.

    Hello, Have an 2003 Jetta ALH, standard, 200K, that had a bad left front abs sensor wire & abs dash light on. Before the sensor was replaced It then started to develop a low speed pulsation in the brake pedal at final stop, while driving straight & turning at low speed only. I thought it was...
  8. A

    Overheating no fans

    Sorry its been a few months to reply my findings and hope this helps someone in the future. Yes it ended up being a head gasket and put a new head/bolts on it as well. Over heating issues resolved. Thanks to all that chimed in!
  9. A

    Overheating no fans

    The one I removed and replaced both had the disc, so no method to the madness, but good point!
  10. A

    Overheating no fans

    update, The new thermo switch arrived today and put it in, topped off coolant, evaced the air out of the cooing system, then test drove. Traveled up hill about 4-5 miles and temp started to rise, pulled off to put the heat gun on the radiator and low and behold the fans were running on high...
  11. A

    Overheating no fans

    Ok, getting back to the oil film I just noticed in the surge tank, could that also be from a cracked/bad EGR?
  12. A

    Overheating no fans

    Just spoke to him it was checked for warpage and didn't have any.
  13. A

    Overheating no fans

    Honestly I can't remember had a friend thats had several VW's do most of it, but will reach out and see what all was done. Work was done 30k ago, could this be something that can happen over time or if warped it would be immediate?
  14. A

    Overheating no fans

    Ok just went out and look in surge tank no that its empty and see a film of black oily substance in the bottom, see pic (nevermind) I can get it to load with my message, so head gasket???
Top