02beater_auto
Well-known member
Hi,
I have a set of these laying around and want to install them....might as well:
What type of adhesive did/would you use?
This looks to be the right stuff:
Anything else?
No, I am not going to do this the right way on the beater.
Thanks.
I have a set of these laying around and want to install them....might as well:
Slip-On Rocker pane fits 99-04 Vw Golff, Jett & GTI l 4 Door rust repair-PAIR | eBay
Pair of Slip-On Rocker panels that fits 99-04 VW Golf, Jetta & GTI 4 Door Size 70" x 9" x 6". However, they are less expensive, easier to install, and will make the vehicle look good. For a higher quality stamped steel rocker look up 4099942L.
www.ebay.com
What type of adhesive did/would you use?
This looks to be the right stuff:
Dual-Mix™ Structural Impact Resistant Adhesive | SEM Products
Dual-Mix™ Structural Impact Resistant Adhesive is an OEM recommended, two-component, epoxy-based adhesive for bonding structural and non-structural components where specified by the vehicle manufacturer.
www.semproducts.com
Anything else?
No, I am not going to do this the right way on the beater.
Thanks.