ctennyson
Well-known member
Hello Gents,
Just had my 2010 Jetta Tdi run through the emissions test at the local Cdn Tire, only to fail the damm thing. It failed due to 3 sensors in a not ready state.
No CEL on but recently had to change an oxygen sensor. I've driven about 1000 km since. I have a vag com, is there a way to set these sensors to a ready state ?
The following sensors are in a "Not Ready" state.
PM Filter
Exhaust Gas Sensor
NOx/SCR Aftertreatment
NMHC Catalyst
How can these be reset ?
Thanks
Just had my 2010 Jetta Tdi run through the emissions test at the local Cdn Tire, only to fail the damm thing. It failed due to 3 sensors in a not ready state.
No CEL on but recently had to change an oxygen sensor. I've driven about 1000 km since. I have a vag com, is there a way to set these sensors to a ready state ?
The following sensors are in a "Not Ready" state.
PM Filter
Exhaust Gas Sensor
NOx/SCR Aftertreatment
NMHC Catalyst
How can these be reset ?
Thanks
Last edited: