Melett CHRA for Turbo Replacement, Will It Fit?

I accidentally posted this in the Jetta "A3" area instead of Audi A3. So this is a repost.

We bought a 2010 Audi A3 TDI (CBEA engine) with no oil pressure. So after replacing the balance shafts and oil pump drive, it is fixed.

The turbo failed because of the low oil pressure, so I bought a used one with 35,000 miles, but it has quite a bit of shaft play.

I found this CHRA (Center Housing Rotating Assembly) built my Melett, but I am not 100% sure that it will fit. What do you think?

http://www.ebay.com/itm/391085673044...:MEBIDX:IT

Take a look at turborebuilduk. They are an authorized reseller of smeller and they will ask for the serial and part number from your turbo. They can even do billet wheels. I wouldn't not trust eBay.

Melett not smeller dang my phone.

Thank you for the reply, and sorry for my slow reply. I did take a look at the website https://www.turborebuild.co.uk/ and I was able to cross my part numbers and find the right CHRA.
This is the one that I bought.

https://www.turborebuild.co.uk/webs...ridge-53037100559-53037100561-Turbo-Core.html

You can find the turbo part numbers on the tag that is on the turbo.