JasonG
Veteran Member
Ran a few numbers:
A 3/32" hole at 20psi will flow 3.6 cfm.
A CR170 would run around 330 cfm at that pressure.
[Edit]
A1/16" hole at 20psi will flow a hair over 1cfm.
[/Edit]
I'm not even sure the maf could detect a 1% difference.
A 3/32" hole at 20psi will flow 3.6 cfm.
A CR170 would run around 330 cfm at that pressure.
[Edit]
A1/16" hole at 20psi will flow a hair over 1cfm.
[/Edit]
I'm not even sure the maf could detect a 1% difference.
Last edited: