Starion_slider
Well-known member
Hello all... Ive just been finishing up odds and ends on my b4 and I decided to look at the shift tower that i knew was getting sloppy. The actual bearing goin into trans is good still but i think the actual “relay lever” bolt or pin is loose causing the problems. Ive looked everywhere online and cant seem to find a correct diagram for this 02A trans. I found a pic that I attached from online. The area its loose is the 2 red dots on left side. I thought mabey it was a bolt at first but it appears to be a pin that is mabey just peened over? Anyone have any experience with these? Let me know thank you.