Steering sensor

I’m getting a code for the steering sensor. Was going to do it in a few days, but was wondering can I just reset the light (with a scanner that I have) or is there some calibration procedure that I need to follow. Any help is appreciated gents!


Sent from my iPhone using Tapatalk

Remove the airbox and clean/tighten the major chassis ground hidden underneath it. Driving the car for a few blocks usually resets the steering light to off.

Did that and replaced the steering angle sensor under steering wheel. Light came back saying that it’s a steering torque sensor now.

Does anyone have a diagram or part numbers for the sensors on the rack?


Sent from my iPhone using Tapatalk

I am not sure if the sensor on the rack is replaceable. If you end up needing a steering rack, let me know, I have two extra (the one that I have on my car has developed a vertical play in it, I was planning to change it, but I did not get to it yet).