Is it better to pull the transmission when I pull my gas motor when I go to swap in the BHW? Or, can I leave it in and install the BHW without much of an issue?
I have pulled the engine/tranny when I did the 6mt swap a few years ago. I was just hoping with the BHW being smaller than the 2.7T that I could get away with leaving the transmission in.
Sounds like in the long run, it would be best to pull both.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.