SeanDieselB
Member
So I need help, I machined down my flywheel before I replace the clutch and it turned out well... I think.
The issue is that I didn't realize you need to machine the top where the pressure plate bolts down as well?
I didn't check what the difference in height was between the two before I started so now I don't know how much material I removed from the face of the flywheel. Does anyone have access to a good flywheel that can measure the height of the step?
in 1,000s of an inch please!
The issue is that I didn't realize you need to machine the top where the pressure plate bolts down as well?
I didn't check what the difference in height was between the two before I started so now I don't know how much material I removed from the face of the flywheel. Does anyone have access to a good flywheel that can measure the height of the step?
in 1,000s of an inch please!