ewenmaclean
Veteran Member
Hello,
I want to be able to program new keys to my T4 van - especially as I think the ignition switch is soon to fail. I have VCDS to match the keys, and am trying to use vag-tacho to get the SKC (pin). I successfully connect to the instruments and can read the eeprom - the clocks are VDO 7D0920900B with immo 6H0953257A. Unfortunately the PIN is always returned as 0000.
I am not sure if the SKC is kept in the clocks and the separate immo box. When I try to retrieve from the immo box it says "Access Denied". I was under the impression the SKC was only in the cluster.
I'd really appreciate any help or advice here - in particular if it is possible to know from the eeprom which bits correspond to the SKC. I can post the eeprom too if it is helpful.
thanks very much in advance
I want to be able to program new keys to my T4 van - especially as I think the ignition switch is soon to fail. I have VCDS to match the keys, and am trying to use vag-tacho to get the SKC (pin). I successfully connect to the instruments and can read the eeprom - the clocks are VDO 7D0920900B with immo 6H0953257A. Unfortunately the PIN is always returned as 0000.
I am not sure if the SKC is kept in the clocks and the separate immo box. When I try to retrieve from the immo box it says "Access Denied". I was under the impression the SKC was only in the cluster.
I'd really appreciate any help or advice here - in particular if it is possible to know from the eeprom which bits correspond to the SKC. I can post the eeprom too if it is helpful.
thanks very much in advance