Cottickc
Member
I’m new here and have done a fair bit of research, but with so much knowledge on this site I figured I would look for assistance. I got the BHW out of the donor 2004 Passat, I have the entire wire harness that was in the engine bay(unplugged it from the ECU and electrical block under it). I am swapping into a 1994 Toyota 4X4 pickup with a manual transmission Here are my questions:
1). What do I need from the inside wire harness besides the accelerator pedal and scanner plug?
2). Thoughts on swapping to the old style oil pump from the balance shaft model I currently have?
3). Thoughts on the EGR delete?
4). Was going to send the ECU to Malone tuning to have the immobilization removed and a stage 2 tune, anything else I need done to get it to run?
I’m good on all the mechanical and fabrication work, it’s the electrical portion I could really use some advice.
Thanks
1). What do I need from the inside wire harness besides the accelerator pedal and scanner plug?
2). Thoughts on swapping to the old style oil pump from the balance shaft model I currently have?
3). Thoughts on the EGR delete?
4). Was going to send the ECU to Malone tuning to have the immobilization removed and a stage 2 tune, anything else I need done to get it to run?
I’m good on all the mechanical and fabrication work, it’s the electrical portion I could really use some advice.
Thanks