Steve Addy
Top Post Dawg
Not much new here, rear beam axle bushings arrived, the press tool has been ordered but might take a while to get. After venturing out into the mud yesterday looking for a replacement rear proportioning valve only to find all the candidates frozen to the ground still, so getting that will have to wait a while. We're back down in the single digits for a couple days so I've moved on to cleaning up the mess that is my garage, throwing out junk parts and getting the engine work going.
Pulled the flywheel today and started cleaning that, glad to see that it won't need to be replaced, looks pretty good.
High of 14 tomorrow and windy, probably spend the day getting my engine harness work done and making some decisions about cooling system stuff. I have too many half-finished elements of this project, I have to get some parts done and under control otherwise it'll drive me nuts.
Steve
Pulled the flywheel today and started cleaning that, glad to see that it won't need to be replaced, looks pretty good.
High of 14 tomorrow and windy, probably spend the day getting my engine harness work done and making some decisions about cooling system stuff. I have too many half-finished elements of this project, I have to get some parts done and under control otherwise it'll drive me nuts.
Steve